Gate manufacturers analyze the common malfunctions of swing gates, flap barriers, and tripod turnstiles during use?

As channel gate products, swing gates, flap barriers, and tripod turnstiles inevitably experience some malfunctions during use, affecting their normal operation.  Now, the InnovateLink editor will analyze some common problems and solutions for swing gates, flap barriers, and tripod turnstiles to help you.

1. After powering on, the direction indicator of the swing gate, flap barrier, or tripod turnstile does not display correctly, and the device cannot read cards normally. The main reason for this type of failure is an abnormality in the device's power system. We should carefully check whether the fuse of the main controller is damaged, whether the connectors are loose, or whether the power cord is broken;

2. After reading the card, the swing gate, flap barrier, or tripod turnstile fails to open. However, it can be opened manually or by remote control. This type of failure is usually caused by a broken connection between the card reader and the gate control board, or a malfunction of the card reader.  It is recommended to contact relevant technical personnel for inspection and maintenance, and avoid blind operation to prevent causing other new problems to the gate;

3. During the use of the swing gate, flap barrier, or tripod turnstile, the swing arm cannot be locked normally. This type of failure is mainly due to a damaged electromagnet or a disordered control program. The electromagnet should be replaced, and the control program should be checked for problems;

4. The swing gate, flap barrier, or tripod turnstile cannot read cards normally. Check whether the wiring between the card reader and the main controller is loose or whether the card reader is damaged. If the card reader is damaged, it should be replaced to ensure the normal use of the gate.